boom audio installation instructions harley

#BOOM AUDIO INSTALLATION INSTRUCTIONS HARLEY INSTALL#
#BOOM AUDIO INSTALLATION INSTRUCTIONS HARLEY MANUAL#

Drill two 7.25 mm (9/32 in) holes at the connector flange mounting pilot hole locations. hand & power tools, audio-visual equipment or party accessories, you will find just what you. Verify size of cutout (4) with the 18-way flanged connector on the saddlebag harness (see Figure 13, Item 4) from the kit.Ĭut the cutout for connector into the saddlebag wall. Count on us to help you find the best solution for your. Remove the wire and grommet.Ĭarefully cut the cutout (4) in the template (1) for connector on the dashed line.ĭrill two pilot holes (5) for the connector flange mounting locations. This went on during the week and I can't get through a song whether it be on my USB or through the radio. Just last weekend my audio started cutting out (pausing) then starting again.

Get the red wire (8) with the power connector and in-line fuse holder cut from the amp and speaker harness in Step 4. JWright60 said: I have a 2016 FLHTK (Ultra Limited) with the Boom Box. This app makes it easy to setup and configure the audio system. Installation is simple when the installation instructions are followed, step by step. This is the companion app for the Harley-Davidson Audio powered by Rockford Fosgate system.

#BOOM AUDIO INSTALLATION INSTRUCTIONS HARLEY MANUAL#

Tighten per service manual specifications. download The majority of HSR42/45 installations use the Harley cable.

#BOOM AUDIO INSTALLATION INSTRUCTIONS HARLEY INSTALL#

If saddlebag lid speakers are present from a previous installation, left side speaker wires could be in the connector cutout location. Install the relay black wire ring terminal onto to the vehicle ground stud with the amp and speaker harness black wire ring terminal (7), and install the nut removed in Step 1. Trace the cut outline (4) for connector onto the saddlebag.

Align the grommet (2) and latch fastener (3) openings. Place the saddlebag on a protected surface with the mounting (inboard) side facing up. Click here to go directly to the assembly instructions for article 76000202 on the Harley-Davidson Service Portal. Cover both sides of the area being drilled or cut with masking tape. The riders safety depends upon the correct installation of this kit.

To minimize damage to paint during cutting and drilling. This item is available from a Harley-Davidson dealer.

Boom audio installation instructions harley